Yamaha TRACER MT09TRA Service Manual page 289

12.Measure:
• Valve clearance
Out of specification  Adjust.
Refer to "ADJUSTING THE VALVE CLEAR-
ANCE" on page 3-5.
13.Install:
• Timing mark accessing bolt "1"
Timing mark accessing bolt
15 Nm (1.5 m·kgf, 11 ft·lbf)
• Crankshaft end cover "2"
Crankshaft end cover
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
14.Install:
• Timing chain guide (top side)
• Cylinder head cover gasket "1"
• Cylinder head cover
Cylinder head cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Apply Three Bond No.1541C® onto the mating
surfaces of the cylinder head cover and cylin-
der head cover gasket.
• After installing the cylinder head cover gasket
"1" to the cylinder head cover, cut off the "a"
section.
15.Install:
• Spark plugs
• Ignition coils "1"
2
TIP
Install the ignition coils "1" in the direction shown
in the illustration.
New
5-18
CAMSHAFTS
a
Spark plug
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
1
1