D-Mode (Drive Mode) - Yamaha TRACER MT09TRA Service Manual

All Reset
TIP
The odometer and the clock cannot be reset.
Self-diagnosis mode
1
1. Immobilizer system indicator light " "
2. Engine trouble warning light "
3. Error code display
This model is equipped with a self-diagnosis de-
vice for various electrical circuits. If a problem is
detected in any of those circuits, the engine trou-
ble warning light will come on and the informa-
tion display will indicate an error code.
If the information display indicates any error
codes, note the code number, and then check
the fuel injection system. (Refer to "FUEL IN-
JECTION SYSTEM" on page 8-31.)
The self-diagnosis device also detects problems
in the immobilizer system circuits.
If a problem is detected in the immobilizer sys-
tem circuits, the immobilizer system indicator
light will flash and the information display will in-
dicate an error code when the key is turned to
"ON".
TIP
If the information display indicates error code 52,
this could be caused by transponder interfer-
ence. If this error appears, try the following.
1. Use the code re-registering key to start the
engine.
TIP
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
NO
YES
GEAR
N
A.TEMP °C
25
C.TEMP °C
Lo
TIME TRIP
0:00
2 3
"
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal inter-
ference, which may prevent the engine from
starting.
2. If the engine starts, turn it off, and try starting
the engine with the standard keys.
3. If one or both of the standard keys do not start
the engine, re-register the standard keys.
If the display indicates any fault codes, note
the code number, and then check the vehicle.
(Refer to "FUEL INJECTION SYSTEM" on
page 8-31 and "IMMOBILIZER SYSTEM" on
page 8-81.)
ECA11591
NOTICE
If the display indicates an error code, the ve-
hicle should be checked as soon as possible
in order to avoid engine damage.
EAS31049

D-mode (drive mode)

D-mode is an electronically controlled engine
performance system with three mode selections
("STD", "A", and "B").
Push the drive mode switch "MODE" to switch
between modes.
1. Drive mode switch "MODE"
TIP
Before using D-mode, make sure you under-
stand its operation along with the operation of
the drive mode switch.
Mode "STD"
Mode "STD" is suitable for various riding condi-
tions.
This mode allows the rider to enjoy smooth and
sporty drivability from the low-speed range to the
high-speed range.
Mode "A"
Mode "A" offers a sportier engine response in
the low- to mid-speed range compared to mode
"STD".
1-31
FEATURES
1