Changing The Engine Oil - Yamaha TRACER MT09TRA Service Manual

minutes until the oil has settled.
EAS30657

CHANGING THE ENGINE OIL

1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
• Engine oil filler cap "1"
• Engine oil drain bolt "2"
• Gasket "3"
1
2 3
A. MT09TRA for Europe: RN29F0011886 and
after
MT09TRAG for Oceania: RN29K 0000556
and after
4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil filter cartridge is also to be replaced,
perform the following procedure.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the oil filter cartridge "1" with an oil
filter wrench "2".
b. Lubricate the O-ring "3" of the new oil filter
cartridge with a thin coat of engine oil.
ECA13390
NOTICE
Make sure the O-ring "3" is positioned cor-
rectly in the groove of the oil filter cartridge.
3
2
c. Tighten the new oil filter cartridge to specifi-
cation with an oil filter wrench.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6. Install:
• Engine oil drain bolt
(along with the gasket
7. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
3-25
PERIODIC MAINTENANCE
Oil filter wrench
90890-01426
Oil filter wrench
YU-38411
2 1
Oil filter cartridge
17 Nm (1.7 m·kgf, 12 ft·lbf)
New
Engine oil drain bolt
43 Nm (4.3 m·kgf, 31 ft·lbf)
3
)