Fault code No.
Item
2
Defective intake air pressure
sensor 1.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
01
Meter display
Procedure
Meter display
13
Procedure
Item
Probable cause of
malfunction and check
14
Intake air pressure sensor 1: hose system malfunction (clogged or
detached hose).
Execute the diagnostic mode.
(Code No. 03)
When engine is stopped:
Atmospheric pressure at the
current altitude and weather
conditions is indicated.
At sea level: Approx. 101 kPa
(757.6 mmHg, 29.8 inHg)
1000 m (3300 ft) above sea
level: Approx. 90 kPa (675.1
mmHg, 26.6 inHg)
2000 m (6700 ft) above sea
level: Approx. 80 kPa (600.0
mmHg, 23.6 inHg)
3000 m (9800 ft) above sea
level: Approx. 70 kPa (525.0
mmHg, 20.7 inHg)
When engine is cranking: Make
sure that the indication value
changes.
The value does not change
when engine is cranking.
Check the intake air pressure
sensor 1.
Replace if defective.
Refer to "CHECKING THE
INTAKE AIR PRESSURE SEN-
SOR" on page 8-146.
15
Throttle position sensor: open or short circuit detected.
Able/Unable to start engine
Able/Unable to drive vehicle
01, 13
Throttle position sensor signal 1
• 11–21 (fully closed position)
• 96–106 (fully open position)
• Check with throttle valves fully closed.
• Check with throttle valves fully open.
Throttle position sensor signal 2
• 9–23 (fully closed position)
• 94–108 (fully open position)
• Check with throttle valves fully closed.
• Check with throttle valves fully open.
Maintenance job
8-42
FUEL INJECTION SYSTEM
Confirmation of service com-
pletion