Yamaha TRACER MT09TRA Service Manual page 526

1
8. Check:
• Battery terminals
Dirt  Clean with a wire brush.
Loose connection  Connect properly.
9. Lubricate:
• Battery terminals
Recommended lubricant
Dielectric grease
10.Install:
• Rider seat/Passenger seat
Refer to "GENERAL CHASSIS (1)" on page
4-1.
EAS30553
CHECKING THE RELAYS
Check each switch for continuity with the pocket
tester. If the continuity reading is incorrect, re-
place the relay.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
1. Disconnect the relay from the wire harness.
2. Connect the pocket tester (  1) and battery
(12 V) to the relay terminal as shown.
Check the relay operation.
Out of specification  Replace.
2
8-135
ELECTRICAL COMPONENTS
Starter relay
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Relay operation
Continuity
(between "3" and "4")
Relay unit (starting circuit cut-off relay)
1. Positive battery terminal
2. Negative battery terminal
3. Positive tester probe
4. Negative tester probe
Result
Continuity
(between "3" and "4")