Removing The Heater, The High-Limit Thermostat, & Thermal Cutoff - Whirlpool duet GGW9200L Series Job Aid

REMOVING THE HEATER, THE HIGH-LIMIT
THERMOSTAT, & THERMAL CUTOFF
NOTE: Sharp edges may be present.
1. Turn off the gas to the dryer and discon-
nect the electrical power.
2. Remove the two hex-head screws from
the bottom flange of the toe panel. Pull the
panel out at the bottom, pull down, and
remove the panel.
Toe Panel
Toe Panel Screws
Thermal Cutoff, & Heater Area
3. Remove the hex-head screw from the
heater shield and remove the shield.
Heater
Shield
Screw
High-Limit Thermostat,
4. To remove the heater:
a) Remove the two wires from the termi-
nal block (see bottom photo).
b) Remove the hex-head screw from the
heater housing, and slide the heater
out of the duct.
5. To remove the high-limit thermostat or
the thermal cutoff:
a) Disconnect the wires from the high-
limit thermostat or the thermal cutoff.
b) Remove the two hex-head screws.
High-Limit Thermostat
(Red-White & Black Wires)
Thermal Cutoff
(Red & Black Wires)
4-10
Heater Housing
Screw
Heater Terminal Block
(Red & Red-White Wires)