Whirlpool duet GGW9200L Series Job Aid page 28

• Press the Wrinkle Shield feature button, if
this option is desired.
• Press the End Of Cycle Signal button to set
the signal volume to the desired level.
• Press and hold the Hold To Start button until
the dryer starts (about 1 second).
Once an Automatic Cycle has started, the
Wrinkle Shield feature, and the End Of Cycle
Signal level can be adjusted. Press the Pause/
Cancel button twice to stop the dryer and clear
the settings, allowing you to select another
cycle and dryness level.
To use a Manual Cycle:
• Rotate the dial to select a Manual Cycle.
• Press More Time or Less Time until the
desired drying time is displayed. Tap More
Time or Less Time and the time will change
by 1 minute intervals. Press and hold More
Time or Less Time and the time will change
by 5 minute intervals.
NOTE: The More Time or Less Time feature
can only be used with Manual Cycles.
More
Time
Less
Time
• Press the Temperature button until the de-
sired temperature is indicated.
NOTE: Pressing the Dryness Level button will
cause the triple beep, indicating that this option
is not selectable. Also, a dryness level is not
indicated.
The initial time displayed is the actual drying
time. As the cycle runs, the control senses the
dryness of the load, and adjusts the time auto-
matically for the selected dryness level.
• Press and release the Wrinkle Shield button
if this option is desired.
• Press the End Of Cycle Signal button to set
the volume to the desired level.
• Press and hold the Hold To Start button until
the dryer starts (about 1 second).
During a Manual Cycle, you can change the
settings for Time, Temperature, the Wrinkle
Shield feature, and the End of Cycle Signal
functions. Press the Pause/Cancel button twice
to stop the dryer and clear the settings, allow-
ing you to select another cycle.
STOPPING THE DRYER
To stop the dryer at any time:
• Press the Pause/Cancel button twice.
PAUSING OR RESTARTING
To pause the dryer at anytime:
• Open the door or press the Pause/Cancel
button once.
To restart the dryer:
• Close the door and press and hold the Hold
To Start button until the dryer starts.
NOTE: Drying will continue from where the
cycle was interrupted if you close the door and
press Start within 5 minutes. If the cycle is
interrupted for more than 5 minutes, the dryer
will shut off. Select the new cycle settings
before restarting the dryer.
CONTROL LOCKED
This feature allows you to lock your settings to
prevent unintended use of the dryer. You can
also use this feature to prevent unintended
cycle changes during dryer operation.
To enable the Control Locked feature:
Press and hold the End Of Cycle Signal button
for 3 seconds. The control is locked when a
single beep is heard and the Control Locked
status light is on.
• When the dryer is off, it is not necessary to
press the Control On button before activat-
ing the Control Locked feature.
To unlock the Control Locked feature:
Press and hold the End Of Cycle Signal button
for 3 seconds to turn this feature off.
NOTE: When the dryer is running and Control
Locked is on, the dryer can be stopped by
pressing the Pause/Cancel button, but cannot
be restarted until the control is unlocked.
3-2