Removing The Rear Air Duct, Heaters, Thermal Fuse, Thermostats, And Ntc - Whirlpool W11440958 Technical Manual

COMPONENT ACCESS (Cont.)
Removing the Rear Air Duct, Heaters, Thermal Fuse,
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Remove the top and side panels (page 4-3).
3. Remove the three (3) Torx T20 screws (see Figure A and B).
4-10 Whirlpool 24" Compact Condensing Dryer
n
®
Thermostats, and NTC
Figure A
Figure B
4. Disconnect the heaters and NTC connectors (see Figure 1).
5. Using a flat blade screwdriver to push in on heater
connector tab to disengage it from rear duct panel (see
Figure 2).
6. Remove the nine (9) T20 screws holding the rear duct panel
(see Figure A and B).
Figure 1
Figure 2
Figure A