Whirlpool duet GGW9200L Series Job Aid page 45

DRUM INSTALLATION NOTE: Be sure to po-
sition the drum with the clip toward the front
when you reinstall it.
Front
Install Drum
NOTE: There are two rollers on the front panel
and two on the rear panel, as shown below.
Front Panel (inside)
Front Rollers
Position Clip
Towards Front
Rear Panel (inside)
Rear Rollers
4-13
11. To remove a roller:
a) Pry the sides of the triangular ring out
of the groove in the roller support with
a small screwdriver.
Triangular Ring
b) Slide the roller off the roller support.
Roller Support
c) Use a 9/16" socket or open-end
wrench, and remove the hex nut and
flat washer from the roller support, and
remove the support. NOTE: If you are
replacing the roller support, remove the
other triangular ring from the support.
9/16" Nut & Flat Washer
Roller Support
Triangular
Ring