Removing The Belt, Drum, & Rollers - Whirlpool duet GGW9200L Series Job Aid

REMOVING THE BELT, DRUM, & ROLLERS
NOTE: Sharp edges may be present.
1. Turn off the gas to the dryer and discon-
nect the electrical power.
2. Pull the dryer away from the wall and
remove the top cover (see steps 3 and 4
on page 4-2 for the procedure).
3. Remove the console (see page 4-4 for the
procedure).
4. Remove the lint duct (see steps 2 through
5 on page 4-7 for the procedure).
5. Reach around behind the drive motor and
push the idler wheel arm to the left, then
remove the tension, and remove the belt
from the idler pulley.
6. Disconnect the 3-wire moisture sensor
connector from the main harness connec-
tor.
Remove Belt
From Idler Pulley
Push To Left
Moisture Sensor
Connector
4-11
7. Disconnect the 3-wire door switch con-
nector from the machine control electron-
ics board connector.
8. Loosen the two top front panel screws.
Top Front Panel Screws
9. Remove the two bottom front panel screws.
Bottom Front Panel Screws
Continued on the next page.
3-Wire
Door Switch
Connector