Whirlpool duet GGW9200L Series Job Aid page 41

g) Lift the top locking tab of the motor
harness plug and pull the top pins away
from the motor connector, then release
the bottom tab, and remove the plug.
Top Locking Tab
h) Remove the two hex washer-head
mounting screws from the drive motor,
then lift the right side of the motor
slightly, pull the two tabs on the left side
out of the chassis slots, and remove the
drive motor.
Hex Washer-Head Screws
Motor Harness Plug
4-9
8. To remove the belt switch:
a) If not already done, remove the drive
motor (see step 7 on page 4-8).
b) Remove the 3/8" hex shoulder-washer
screw from the idler pulley assembly
and remove the assembly.
Idler Pulley Assembly
c) Remove the two screws from the belt
switch and remove it from the motor.
d)Disconnect the blue wires from the belt
switch terminals.
Blue Wire
Belt Switch
3/8" hex shoulder-
washer screw
Belt Switch Screws
Blue Wire