Removing The Console & The Touchpad Subassembly - Whirlpool duet GGW9200L Series Job Aid

NOTE: Sharp edges may be present.
1. Turn off the gas to the dryer and discon-
nect the electrical power.
2. Pull the dryer away from the wall and
remove the top cover (see steps 3 and 4
on page 4-2 for the procedure).
3. Remove the three screws from the ma-
chine control electronics board bracket,
and tip the bracket assembly inside the
dryer (see step 5 on page 4-2 for the
procedure).
4. Disconnect the ends of the two ribbon
cables from the machine control electron-
ics board connectors P3 and P4.
P4
Press In On Clips To
Release Cables
5. Remove the two screws from the console
bracket.
Console Bracket Screws
REMOVING THE CONSOLE & THE
TOUCHPAD SUBASSEMBLY
P3
Machine
Control
Electronics
Board
6. Open the door and pull out on the bottom
of the console to release the locking tabs
from the door panel.
7. Lift the console straight up until the brack-
ets are free of the left and right side panel
flanges and remove the console.
Viewed From Back Of Console
8. Place the console assembly on a padded
work surface with the bracket side facing
up, as shown in step 9.
4-4
Lift Console Bracket From
Flange On Both Sides
Side Panel Flange