Reversing The Door Swing - Whirlpool duet GGW9200L Series Job Aid

Door Reversal Kit:
Key Description
1 Handle Filler
2 Hinge Cover
3 Door Handle
LOOSEN THE DOOR TRIM
1. Place a towel or a soft cloth on top of the
dryer or work space to protect the door
surface.
2. Loosen the plastic trim (1) above and
below the handle filler (2).
3. Carefully pull out on the trim until it un-
snaps and remove the handle filler and set
it aside.
1
4. Loosen the plastic trim (1) above and
below the hinge cover (3).
5. Carefully pull out on the trim until it un-
snaps, remove the hinge cover, and set it
aside.
1

REVERSING THE DOOR SWING

2 3
1
2
3
NOTE: Keep the original handle filler and hinge
cover in case you decide to return the door to
its original position. A new handle filler and
hinge cover are provided in the door reversing
kit that will be installed in a later step.
REMOVE THE DOOR
1. Open the dryer door.
2. Loosen the top keyhole screw, then re-
move the other four hinge screws.
Loosen This
Hinge Screw
3. Lift the door from the top keyhole slot
screw and place it on a padded surface
with the inside door assembly facing up.
4. Remove the top keyhole slot screw and
place it with the others.
Continued on the next page.
2-11