Seat Depth Adjustments; Control Adjustment; Dual/Attendant Control (Where Fitted); Parallel Swing-Away Control - Sunrise Medical QUICKIE Q100R General Manual

14.6 Seat depth adjustments: (Fig. 14.6).
Remove the 2 bolts on the backrest brackets 1 for each side of
the frame, using a 6mm Allen key and 13.0mm spanner. Move
the backrest into the seat depth position required. Re-assemble
bolts and tighten to a torque of 17-20Nm. To compensate for
the armrest position, both the sideguard and the armpad are
adjustable.
There are 5 Seat depths; 410 to 510mm in 25mm steps.
14.7 Control Adjustment (Fig. 14.7):
The control can be adjusted to various positions by pushing it along
the armrest. The control can be moved by turning the lever below
the arm pad anti-clockwise, reposition the controller and secure by
turning the lever clockwise to tighten.
WARNING!
• Do not replace the joystick knob with any unauthorised item.
It may cause hazardous operation and loss of control of the
chair.
• It is important that the joystick boot is replaced if it is torn or
brittle; failure to do so could cause substance damage to the
controller and unexpected movement of the chair.
• Ensure that you always have comfortable access to the
controls whilst the chair is moving and make sure that the
controller is fixed securely to the chair.

14.8 Dual/Attendant control (Where fitted)

WARNING!
• Ensure that you set the speed of the attendant control to a
speed that you can comfortably follow.
• Always turn off the power to the controller when leaving the
user in the chair. (See sections 11.10 - 11.14).
14.9 Parallel swing-away control (Fig.14.8):
WARNING!
• Before adjusting the swing-away arm, switch off the controller
to avoid accidental displacement of the joystick which would
cause unwanted movement of your wheelchair.
• Keep your fingers and clothing, etc. clear while operating the
swing-away mechanism.
• Be aware that the width of your chair has increased if the
swing-away arm is out and you may not get between certain
obstacles.
• Do not hang any items on or over the parallel swing-away
remote assembly as this could damage the swing-away
mechanism.
• When transferring to and from the wheelchair do not use the
remote as a means of support.
• Keep fingers, clothing, etc. clear of the swing-away mechanism
at all times.
• Ensure the power is switched off while adjusting the parallel
swing-away arm.
• Only operate the wheelchair at low manoeuvring speed when
Fig. 14.6
the parallel swing-away is in use, (Fig.14.8).
Fig. 14.7
Fig. 14.8
Q100R-Q200R Configured Rev. A
57