Rear View Mirror - Sunrise Medical QUICKIE Q100R General Manual

WARNING!
Advice to Client
The lap belt must be checked on a daily basis to ensure it is
adjusted correctly and it is free from any obstruction or adverse
wear.
DANGER!
Failure to make sure that the lap belt is secure and adjusted
prior to use could cause serious injury to the user. E.g. too loose
a strap may allow the user to slip down in the chair and risk
suffocation.
WARNING!
Maintenance:
• Check lap belt, and securing components; at regular intervals
for any sign of fraying or damage.
• Replace if necessary.
• Clean the lap belt with warm soapy water and allow to dry.
• The lap belt should be adjusted to suit the end user as detailed
above.
• Sunrise Medical also recommend that the length and fit of the
belt is checked on a daily basis to reduce the risk of the end
user inadvertently re-adjusting the belt to an excessive length.
• If in doubt about the use and operation of the seat belt then
ask your healthcare professional, wheelchair dealer, carer or
attendant for assistance.
WARNINGS!
• The rider plus item should never exceed a total weight as
defined in Section 16 Specification Sheets.
• Before you use the chair, carefully check the functionality.
• If you discover any chair malfunction, take it to be repaired or
reset. Your dealer can help you to find the fault and correct it.
• Make sure batteries are charged. Do not use the chair when
battery is low. The chair may come to a sudden, unexpected
stop.
• Be aware that there is a point during every transfer when the
wheelchair seat is not below you.
• Use extra care when you drive your chair in reverse. If one of
the wheels hits an obstacle, you could lose control of the chair
or fall out.
• Never use your chair on a slope unless you are sure you can do
so without losing traction.
• Lift the chair only by non-detachable parts of the main frame.
• Never short-circuit electrical connections as you could cause
an explosion.
• Do not use this chair if fitted with pnuematic tyres that are
under or over-inflated.
• When using mobile phones you should switch off the chair to
avoid causing electromagnetic radiation.

6.14 Rear View Mirror:

To fit the rear view mirror, (Fig. 6.5 - 6.7):
• Remove controller – 2 screws
• Remove controller plate – 2 screws
• Remove mirror bracket and turn over
• Re-assemble controller plate, ensuring mirror fixing hole
(Ø8.5mm) is visible – 2 screws – torque 1 to 1.5Nm
• Assemble mirror to mirror bracket.
WARNING!
• Take care when close manoeuvring as the mirror may catch
on people or objects.
• Do not hang objects off the mirror.
• If affected by glare, tilt the mirror slightly.
• Keep the mirror clean.
Q100R-Q200R Configured Rev. A
Fig. 6.5
Fig. 6.6
Fig. 6.7
25