Lights; Troubleshooting; Locking The Controller - Sunrise Medical QUICKIE Q100R General Manual

12.8 Lights

With the R-net it is possible to control the following lights:
Lights (I in Fig. 12.3)
Hazard Lights (J in Fig. 12.3)
Direction indicators (K1 and K2 in Fig. 12.3)

12.9 Troubleshooting

If the wheelchair will not function while the batteries are fully
charged, check the following points before consulting your
dealer:
Switch the controller off and then switch it on again. Check to
see if the malfunction has been solved.
Check if the free wheel switch was switched to Drive.
Check if the joystick was in the 0 position when the controller
was switched on. In other words, the joystick must not be
moved when the controller is being switched on or off.
Malfunctions list
An extended malfunction list can be found in the appendix of
the service manual (for qualified specialists only). The service
manual can be found on www.SunriseMedical.eu
50
Q100R-Q200R Configured Rev. A

12.10 Locking the controller

The control system can be locked in one of two ways. Either
using a button sequence on the keypad or with a physical
key. How the control system is locked depends on how the
wheelchair manufacturer has programmed
the system.
Keypad Locking
To lock the wheelchair using the keypad;
• While the control system is switched on, depress and hold
the on/off button.
• After 1 second the control system will beep. Now release the
on/off button
• Deflect the joystick forwards until the control system beeps.
• Deflect the joystick in reverse until the control system beeps.
• Release the joystick, there will be a long beep.
• The wheelchair is now locked.
To unlock the wheelchair using the keypad;
• If the control system has switched off, press the on/off
button.
• Deflect the joystick forwards until the control system beeps.
• Deflect the joystick in reverse until the control system beeps.
• Release the joystick, there will be a long beep.
• The wheelchair is now unlocked.
Key Locking (optional)
To lock the controller with the special key (H1 in Fig. 12.10):
• Insert and remove the special key into the Charger Socket on
the Controller (G in Fig. 12.10). The controller is now locked
and the following screen will be displayed.
To unlock the controller with the special key:
• If the control system has switched off, press the On/off (B in
Fig. 12.3).
• Insert and remove the special key into the Charger Socket
on the Controller (G in Fig. 12.10). The controller is now
unlocked.
Fig. 12.10