Table of Contents
Advertisement
4.0 Setting up the seating system
The average wheelchair user does not exist. This is why Sunrise
Medical wheelchairs can be pre-set according to specific needs of the
user.
Pre-settings are carried out once, the first time the wheelchair is going
to be used. They must be executed by qualified specialist, unless
explicitly stated otherwise.
4.1 Pre-set seat depth
Backrest frame depth (Fig 4.1):
1. Unscrew and remove 2 x (A) on both sides.
2. Adjust (B) to the desired position.
3. Replace and tighten for all (A) fasteners.
4.2 Pre-set seat width
To adjust the seat frame width, the seat plate and back frame width
needs to be adjusted at the same time. For easy explanation these
are mentioned in fig 4.2 and 4.3 separately.
Seat frame width (Fig. 4.2 & 4.3)
Lift the seat cushion off the Velcro© strips to access the seat plates.
1. Unscrew and remove 10 x (A).
2. Adjust (B) to the desired position.
3. Adjust (C) to the desired position.
4. Replace and tighten all (A) fasteners.
NOTE / CAUTION!
There are 2 sizes of the back frame width adjustment. One for 30-34
cm and one for 36-40 cm.
8
B
2
A
2
1
M5
A
4
M5
2
M5
1
13mm
4
M5
13mm
Zippie & Teens Seat Rev. A
Fig. 4.1
M5
1
3
M5
Fig. 4.2
B
B
Fig. 4.3
C
A
Advertisement
Table of Contents
