Vr2-L - Sunrise Medical QUICKIE Q100R General Manual

11.9 VR2-L

There are common controls between the VR2 and the VR2-L
control systems where a control differs it will be described
below. All common controls can be found on the previous
page.
Lights and indicators:
The wheelchair can be equipped with lights and indicators.
Where lights are not factory fitted, they may be fitted as an
optional extra by an approved Sunrise Medical authorised
dealer.
WARNING!
Ensure that the lights and indicators are functioning correctly
and lenses are clean before going outdoors at night.
Indicators:
To turn on the wheelchairs indicators operate the required
button either left or right, the associated LED will also
illuminate continuously.
If the LED flashes rapidly either a total short circuit, a single
lamp open circuit or a total open circuit in the left or right
indicator circuit has been detected.
Depress the indicator button to turn off the indicator and the
associated LED.
Main lights:
To turn on the wheelchairs lights operate this button, the
associated LED will illuminate continuously.
If the LED flashes a short circuit in the lighting circuit has been
detected.
Depress the light button to turn off the lights and the
associated LED.
Hazard warning lights:
To turn on the wheelchairs hazard warning lights operate this
button, the associated LED will flash at the same rate. The left
and right turn indicator LEDs will also flash.
If the LED flashes rapidly either a total short circuit, a single
lamp open circuit or a total open circuit in the entire indicator
circuit has been detected.
Depress the hazard warning button to turn off the lights and
the associated LED.
Actuator button and LEDs:
Depending on whether your wheelchair is fitted with one or
two actuators the operation of this button will differ.
40
Q100R-Q200R Configured Rev. A
Wheelchairs with one actuator
Depressing the actuator button will enter actuator adjustment
mode. This will be indicated by the illumination of both actuator
LED's. Actuator adjustment can then be made by deflecting
the joystick forwards or backwards. To re-enter drive mode,
depress either actuator button.
Wheelchairs with two actuators
Depressing the actuator button will enter actuator adjustment
mode. Depressing the button once illuminates the left LED,
and deflection of the joystick will adjust the actuator motor
connected to that channel. If the right button is depressed
the associated LED will be illuminated, and deflection of the
joystick will adjust the actuator motor connected to the other
channel.
To re-enter drive mode, depress the selected actuator button,
as indicated by the associated LED.
It is also possible to select the other actuator by left or right
movements of the joystick.
HAZARD
LIGHTS
ACTUATOR
LED'S
LIGHTS
ACTUATOR
BUTTON
INDICATORS
Fig. 11.2