Special Transport Requirements - Sunrise Medical QUICKIE Q100R General Manual

Fitting Dahl Backrest Covers (Fig. 5.21-5.22)
• Remove seat belt fixings (13mm socket/6mm allen key)
• Make note of quick release pin location
• Remove quick-release pin
• Assemble seat belt screw and washer to Dahl cover
• Assemble seat belt to screw, seat belt should be located in
cut out
• Push fit cover onto backrest pivot screw
• Assemble quick release pin into correct recline hole
• Assemble nut to seat belt screw and tighten to 5-6Nm.
NOTE!
Necessary covers when using Dahl Docking Station. Not
supplied by Dahl.
Fig. 5.21
Fig. 5.22

5.4 Special transport requirements

Using your wheelchair on the train.
Before you travel, please contact the train operator. They will be
able to supply details of any special requirements/instructions.
We advise you to check the following:
• Is there a suitable and intended "wheelchair" area in the
train for wheelchair users (with adequate turning space to
manoeuvre)?
• Is there a suitable or designated area on the platform for
wheelchair users (with adequate turning space to manoeuvre)?
• Is there suitable boarding access available to allow you to
access the railway carriage and the intended "wheelchair"
area?
• Is the boarding access suitable for the combined mass of the
wheelchair and the occupant?
• Make sure the slope of the boarding access is not greater than
the dynamic safe slope. (See Section 16)
• Any obstacles or thresholds should not exceed the max kerb
climbing capability of your wheelchair. (See Section 16)
Most train operators will provide assistance provided that
arrangements have been made in advance. We suggest you
have you Owner's Manual ready when planning your journey
and contacted them.
Q100R-Q200R Configured Rev. A
19