Pre-Set Power Center Mount Legrest - Sunrise Medical QUICKIE Q100R General Manual

9.4 Pre-set power center mount legrest

DANGER! / WARNING!
• Be aware of your environment to make sure you do not
injure your legs when legrests are extended.
• Always ensure that the legrests or foot plates do not come
into contact with the castors before driving the wheelchair.
• Legrests are not to be used for lifting or carrying the
wheelchair under any circumstances.
• As with all moving parts be careful not to trap your fingers.
Footplate angle
The footplate can be flipped up to aid with stowed
transportation (Fig. 9.10). The footplate can also be held in a
set position other than horizontal if required:
1. Move footplate into desired angle (Fig. 9.11).
2. Then tighten (A - Fig. 9.12) (4 mm Allen key)
DANGER! / WARNING!
• After adjustment and with the seat in its normal drive
position: Ensure there Is a gap of, (>25 mm.), between the
floor and the footplate at all times.
• Perform this test with the user sitting in the chair loading the
legrest
• Using the chair with the legrest set too low might result
in personal injury or damage to the wheelchair and its
surroundings.
Footplate height (Fig. 9.13)
The height of the footplate can also be adjusted. To do this:
1. Loosen nuts (B) and remove screws.
2. Adjust footplate to the desired position.
3. Re-affix screws and tighten (B).
Calf pad position (Fig. 9.14)
The position of the Calf Pads can be adjusted. To do this:
1. Loosen (C) by one turn.
2. Adjust Calf Pads to the desired position.
3. Tighten (C).
36
Q100R-Q200R Configured Rev. A
B
C
Fig. 9.10
Fig. 9.11
Fig. 9.12
A
Fig. 9.13
Fig. 9.14