CyberData 011478 Operation Manual page 123

6. Select the firmware file. This reveals the Upload button
CyberData RFID Video Intercom
Upload button Status Messages
7. Click on the Upload button. After selecting the Upload button, you will see the progress of the
8. When the upload is complete, you will see the words Upload finished under Status Messages.
9. At this point, you will see the progress of the upload's post processing in the Upload Post
Note
10. When the process is complete, you will see the words SWUPDATE Successful under Status
11. The device will reboot automatically.
12. The Home page will display the version number of the firmware and indicate which boot
Operations Guide
Figure 2-70. Upload Button
Upload Post Processing bar
upload in the Upload Progress bar.
Processing bar.
Do not reboot the device before the upgrading process is complete.
Messages.
partition is active.
Installing the SIP Outdoor Video Intercom with RFID
931667A
(Figure 2-70).
Upload Progress bar
CyberData Corporation
116
Intercom Setup