Agilent Technologies OmniBER OTN Series Performance Verification Manual page 75

Verification.book Page 72 Monday, January 19, 2004 1:40 PM
1
Performance Tests
.Load the 8Mb_ITU.msk test mask and check the Positive and Negative pulses are within the mask (see examples).
72
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
8 Mb/s Output Mask Tests
1 Press <Menu>, select Tx/Rx > Transmitter Settings and set
the Signal Mode to PDH/DSn. Now set the Signal Rate to 8
Mb/s.
2 Load the 8Mb_ITU.msk test mask and check the Positive and
Negative pulses are within the mask (see examples).
To test Negative pulse set the Scope Mask Test Set-up panel to Invert
NO TE
Mask
Verification Manual