Installing and aligning the Vitovalor PT2
Fitting the connection set (accessory) to the cylinder module
4x
4x
1.
4x
Fig. 18
1. Install fittings with integral air vent valve on the cyl-
inder module.
2. Fit the connection set (accessory).
Separate installation instructions
3. Fit the supplied edge protector to the opening for
electrical cables.
4.
5.
(cont.)
2.
3.
4. Route 2 cables with plugs
cylinder module. Insert cables at the back of the
gas condensing and fuel cell module.
5. Affix spacer to the cylinder module side panel.
Installation sequence
and
out of the
jF
aBH
27