Safeline SL6+ Manual page 31

OTHER CODES
Receipt to alarm receiver
Break on new alarm
Alarm button delay time
Outputs
Bus unit
- Alarm input
Configuration
CODE DATA
*84* - #
*86* - #
*87* - - #
*88* - - #
*89* - - #
31
COMMENTS
Select which message(s) to send to the
alarm receiver at an alarm call.
0 = None (default)
1 = Start of alarm
2 = Start+end of alarm
Disconnects a call longer than 60 sec. at
new activation of the alarm button and
calls the next emergency call number.
0 = Off
1 = On (default)
Delay time from pressing the alarm but-
ton until activating the alarm.
00-25 seconds. Default = 05
The first number selects the relay output,
i.e. Relay 1 or Relay 2.
The second number selects the function.
For SW 4.00 or later, the following param-
eters are used:
0 = Alarm status outputs (default relay 1)
1 = Battery failure (default relay 2)
2 = Pictogram
(Relay 1 - yellow, relay 2 - green)
3 = Activate with DTMF 8/9
(relay 1 - DTMF 8, relay 2 - DTMF 9)
4 = Manual reset
5 = Emergency call failure
6 = System failure
7 = Emergency bell
Example:
*88*11# - Relay 1, battery failure
*88*26# - Relay 2, system failure
For more information, please refer to
"Relay Functions" (page 33)
For SW previous to 4.00, the following
parameters are used:
0 = Standard (default)
1 = EN81-28 Pictograms
2 = DTMF-controlled
3 = Manual - ECF (Emergency Call Fail)
For more information about the parame-
ters in the older versions, please contact
the support team.
Selected alarm input type for the bus unit
(N/O or N/C).
First number selects the bus unit (1-6).
Second unit selects N/O (0) or N/C (1).
Example:
*89*21# sets bus unit 2 as N/C
EN SL6+ v.3.04