Safeline SL6+ Manual page 30

OTHER CODES
Compatibility mode
Indicator mode
Maximum communication time
Incomming/Outcomming
calls
Reset active alarm
Auto answer
Unit number
Detect dial tone
Configuration
CODE DATA
*77* - #
*78* - #
*79* - #
*80* - #
*81* - - #
*82* - #
*83* - #
30
COMMENTS
0 = Automatic voice switching (default)
The call is validated when there is a
voice response.
The call is terminated by pressing "#".
1 = Kone ECII (lift telephone)
When there is a voice response, some
ascending tones will be heard.
The call is validated by pressing "4".
The call is terminated by pressing "0".
The call is terminated without reciept
notification by pressing "2"(the unit will
call the next number).
2 = Manual voice switching
When there is a voice response, some
ascending tones will be heard.
The call is validated by pressing "4". Unit is
still in automatic mode. '
To enter manual mode and talk press " * ".
To listen press "7".
Go back to automatic mode press "4".
The call is terminated by pressing "#".
It is possible to enter manual voice
switching mode although the unit is
programmed as automatic by pressing " * ".
No ascending tones will be heard.
For repeating the Alarm messages to
operator, press "1" in all in/out going calls.
3 = Swiss Mode (Alarm operator mode)
Only to be used in voice mode.
Disconnect by "0".
Dials the next number if call timeout,
blocking tone, new dailing tone, and
operator silence.
0 = Standard (default)
1 = Strictly EN81-28
1 - 5 minutes.
(Default: VOICE = 5 min, other protocols
= 8 min)
0 = Off
1 = On (default)
Number of signals before SafeLine
answers incoming call.
Can be set from 00-16 (default = 02).
00 = Never answering.
Unit number [0] is set by default,
and means that the unit will respond
immediately.
Unit number [1-9] is used when the
units are sharing the same phone line.
When the unit number is assigned,
the specified unit is accessible for
configuration.
0 = Off
1 = On (default)
Set to off if SafeLine has problem to
detect the dial tone.
EN SL6+ v.3.04