Remote Configuration With Telephone - Safeline SL6+ Manual

Remote
Confi guration
with Telephone:
First Step
Incoming call to SL6+.
1
Dial the phone number
of the SL6+.
Multiple
2
SL6+ connected to
phone number?
3
1 short beep,
fi rst SL6+ answers.
4
Press unit number [1-9].
5
3 long beeps,
SL6+ answers.
Voice communication
mode entered.
Confi guration
In order to remotely confi gure the SL6+, the unit must fi rst
be put into confi guration mode via voice communication
mode. To enter voice communication mode, refer to the
instructions below.
After the unit has been set in voice communication mode,
follow the steps for remote confi guration on the next page.
No
Yes
22
Dial the phone number of the unit's
1
phone.
2 If there is only one unit connected, the
unit answers with 3 long tones.
If there are multiple units connected,
the unit answers with a short beep.
If there are more than one unit
connected to the phone number, use
the unit number to communicate with
the selected unit.
3 After 2 rings the unit answers with a
short beep.
4 If there are two or more SL6+ units
connected in parallel you have to
press the unit number just once.
If there are other units (e.g SafeLine
3000, MX2) connected in serial you
may have to press the unit number
several times before the 3 long tones
are heard.
5 When 3 long tones are heard, the
selected unit is reached and voice
communication mode is established.
Now the telephone beeps every 5
seconds.
This is to notify the passengers of the
ongoing call (anti eavesdropping).
EN SL6+ v.3.04