Configuration Examples - Safeline SL6+ Manual

Confi guration
Examples
If at any time you need to
start over, use the factory
reset command *99*1#.
Please refer to the full
confi guration setup in the
"Parameter list" as these are
merely examples.
Confi guration
SafeLine emergency telephone Units
Example 1.
Storing of two different telephone numbers, one to be
answered by P100 code and the other one with voice.
(For test facility, see example 2.)
1. Start confi guration:
2. 1st phone number:
3. 2nd phone number:
4. Call type 1st number:
5. Call type 2st number:
6. Alarm button delay:
7. End confi guration:
Example 2.
SLCC (SafeLine Call Centre) and 3 day test.
1. Start confi guration:
2. Enter P100 ID code:
Lift ID code (each lift must have its own unique code).
3. Set test alarm type:
4. Set number of days between test alarm:
5. LMS phone number:
(Only if using SLCC)
6. Test alarm:
(For more information, please refer to parameter *17* in the "Parameter list")
7. End confi guration:
25
- Example: Answered with P100 code.
- Example: Answered as voice call.
- Example: 3 seconds delay.
- Example: Test alarm type P100.
- Example: 3 days between test alarm.
EN SL6+ v.3.04