Control Unit - Siemens Sinamics G120P Instruction Manual

Some parameters have more than one associated value. In this case, pressing OK does not take you
directly to the value, but to an index that is displayed in brackets [00] above the actual value.
Example of index parameters
• Pressing OK takes you to [00]
• UP takes you to [01], DOWN back to [00]
• Select an index number of your choice
• Press OK again to edit the index
• The value starts flashing
• Adjust the value by pressing UP or DOWN
• Confirm by pressing OK
Operator Panels BOP-2 and IOP-2:
30
OK
Working with BOP-2
OK OK
A complete list of all parameters
can be found in the "Parameter
Manual: Control Units –
CU230P-2" as a download at:
http://support.automation.
siemens.com/WW/view/
de/70985339/0/en
If you want to adjust any blink-
ing/active value digit-by-digit
(using the UP or DOWN button
might just take too long), you
can always press the OK button
for more than two seconds. After
releasing the button, you can
continuously change any single
digit by using the buttons OK
(move to next digit), ESC (move to
previous digit), UP (increase value),
and DOWN (decrease value).
NOTE