Siemens Sinamics G120P Instruction Manual page 53

Working with the IOP-2
The IOP-2 is mainly operated using the selection wheel. The five additional buttons make it possible to
display certain values or to toggle between the manual and automatic modes. The buttons are as follows:
ON, OFF, ESC, INFO and HAND/AUTO.
4
1
3 6
5
2
1 Turning changes the selection
Pressing confirms the selection
2
Starts the motor in the manual
mode
3 Stops the motor in the manual
mode
4 Takes you back to the previous
screen
5 Displays additional
information
6 Switches the command source
between the HAND and AUTO
modes
The HAND/AUTO function oper-
ates in exactly the same way as
the one implemented in the BOP-2.
After starting the motor with the
ON button, you can change the
setpoint speed by navigating to
CONTROL/SETPOINT and turning
the wheel (clockwise to increase
speed, counter-clockwise to
decrease speed).
NOTE
41