Siemens Sinamics G120P Instruction Manual page 75

2
Creating a new project (Step 1): Give the project a name and click "Next" to access
3
PG/PC Set interface (Step 2): Check that "DEVICE" is set as access point.
If not, click "Access point" and set "DEVICE" in the dialog box
4
Check that "S7USB" is set as interface. If not, click "PG/PC"
5
Open the dropdown menu and select "AccessPoint of the Application"
6
Choose the command "Device (STARTER, SCOUT) --> to S7USB"
7
In the lower section called "Interface Parameter Assigned Used" select "S7USB"
8
Close with OK and click "Next"
2
5
7
3
8
4
6
63