Ils Approach (Armed) Display - Honeywell PRIMUS 1000 Pilot's Manual

The ILS approach mode procedure is described in Table 6–13.
Step
1 Couple either flight director to the autopilot with the FD
transfer switch.
2 Tune the coupled–side navigation receiver to the ILS
frequency for the runway in use.
3 Push the NAV button on the display controller to select ILS
as the navigation source.
4 Set the radio altitude minimums on the PFD with the RA
knob on the display controller.
5 Set the course pointer to the inbound localizer course, and
set the heading bug on the PFD for localizer intercept.
6 Select the approach mode by pushing the APR button on
the mode selector. The PFD annunciates LOC and GS
(both white), as shown in Figure 6–36.
A28–1146–134
REV 1 Jan/03
Procedure

ILS Approach (Armed) Display

Figure 6–36
ILS Approach Mode Procedure
Table 6–13 (cont)
R
PRIMUS 1000 Integrated Avionics System
AD–63890@
Modes of Operation
6-49