Code 11 Set Length 1 - Datalogic PowerScan 9100 Series Product Reference Manual

Code 11 Set Length 1

This feature specifies one of the bar code lengths for
trol. Length 1 is the minimum label length if in
first fixed length if in
check and data characters. The length can be set from 2 to 50 characters.
Table 16
detailed instructions on setting this feature.
Table 16. Code 11 Length 1 Setting Examples
STEP ACTION
Desired Setting (pad with
1
leading zeroes)
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 11 LENGTH 1 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
Select Code 11 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
Fixed Length
provides some examples for setting Length 1. See
EXAMPLES
02 Characters
'0' and '2'
DEFAULT
04 = Length 1 is 4 Characters
Enter/Exit Programming Mode
Variable Length
Mode. Length includes the bar code's
07 Characters 15 Characters
'0' and '7' '1' and '5'
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
pad
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.
CANCEL
Code 11 Length Con-
Mode, or the
page 297 for
50 Characters
'5' AND '0'
Appendix D, Key-
163