Scancode Tables; Control Character Emulation; Single Press And Release Keys - Datalogic PowerScan 9100 Series Product Reference Manual

Control Character Emulation

Control character emulation selects from different scancode tables as
listed in this appendix. Each of the control character sets below are
detailed by interface type in the tables. These apply to Wedge and USB
Keyboard platforms.
Control Character 00 :
character Ctrl+Keys, special keys are located from 0x80 to 0xA1.
Control Character 01 :
character Ctrl+Capital Key, special keys are located from 0x80 to 0xA1.
Control Character 02 :
characters from 0x80 to 0xFE are intended as an extended ASCII table.

Single Press and Release Keys

In the following tables,
right released and so on. Definitions for other keys are Al (Alt left ), Cr
(Control Right ) Cl (Control Left ) Sh (shift). This method can be used for
combining Alt, Control or Shift with other keys.
Example: Consider a Control character set to 00. If AltRight+A is
required before sending a label to the host, it could be done by setting
three Prefix keys in this way: 0x99 0x41 0x9A.
Product Reference Guide
Characters from 00 to 0x1F are sent as control
Characters from 00 to 0x1F are sent as control
Special keys are located from 00 to 0x1F and
Ar↓ means Alt right pressed and
Appendix E

Scancode Tables

Ar↑ means Alt
343