Industrial 2 Of 5 Set Length 1 - Datalogic PowerScan 9100 Series Product Reference Manual

Industrial 2 of 5 Set Length 1

This feature specifies one of the bar code lengths for
Length
Mode, or the first fixed length if in
bar code's data characters only. The length can be set from 0 to 50 charac-
ters.
Table 12
want detailed instructions on setting this feature.
Table 12. Industrial 2 of 5 Length 1 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT INDUSTRIAL 2 OF 5 LENGTH 1 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
Select Industrial 2 of 5 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
Control. Length 1 is the minimum label length if in
provides some examples for setting Length 1. See
EXAMPLES
00 Characters
'0' and '0'
01 = Length 1 is 1 Character
DEFAULT
Enter/Exit Programming Mode
Fixed Length Mode. Length includes the
07 Characters 15 Characters
'0' and '7' '1' and '5'
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by
digits from the Alphanumeric characters in
dix D, Keypad
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code
again.
CANCEL
Industrial 2 of 5
Variable Length
page 297 if you
50 Characters
'5' AND '0'
Appen-
143