Codabar Set Length 2 - Datalogic PowerScan 9100 Series Product Reference Manual

Codabar Set Length 2

This feature specifies one of the bar code lengths for
trolCodabar Length
Variable Length
The length includes the bar code's start, stop, check and data characters.
The length must include at least one data character.
The length can be set from 3 to 50 characters. A setting of 0 specifies to
ignore this length (only one fixed length).
Table 15
instructions on setting this feature.
Table 15. Codabar Length 2 Setting Examples
STEP ACTION
Desired Setting (and pad
1
with leading zeroes)
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODABAR LENGTH 2 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
Select Codabar Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
Control. Length 2 is the maximum label length if in
Mode, or the second fixed length if in
provides examples for setting Length 2. See
EXAMPLES
00 Ignore This
Length
'0' and '0'
50 = Length 2 is 50 Characters
DEFAULT
Enter/Exit Programming Mode
07 Characters 15 Characters
'0' and '7' '1' and '5'
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by
digits from the Alphanumeric characters in
Appendix D, Keypad
character(s). End by scanning the ENTER/EXIT bar
code again.
CANCEL
Codabar Length Con-
Fixed Length Mode.
page 298 for detailed
50 Characters
'5' AND '0'
representing your desired
155