Bc412 Set Length 2 - Datalogic PowerScan 9100 Series Product Reference Manual

BC412 Set Length 2

This feature specifies one of the bar code lengths for
Length 2 is the maximum label length if in
second fixed length if in
check and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to
ignore this length (only one fixed length).
Table 17
instructions on setting this feature.
Table 25. BC412 Length 2 Setting Examples
STEP ACTION
Desired Setting (pad with
1
leading zeroes)
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 11 LENGTH 2 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
Select BC412 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
Fixed Length
provides examples for setting Length 2. See
EXAMPLES
00 (Ignore This
Length)
'0' and '0'
50 = Length 2 is 50 Characters
DEFAULT
Enter/Exit Programming Mode
Variable Length
Mode. Length includes the bar code's
07 Characters 15 Characters
'0' and '7' '1' and '5'
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by
digits from the Alphanumeric characters in
Appendix D, Keypad
character(s). End by scanning the ENTER/EXIT bar
code again.
CANCEL
BC412 Length Control.
Mode, or the
page 298 for detailed
50 Characters
'5' and 0'
representing your desired
199