Datalogic PowerScan 9100 Series Product Reference Manual page 304

References
Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set the value:
1. Determine the desired character or value. A setting of 0xFF indicates
2. Use the
3. Go to
4. Scan the bar code: SELECT DISABLE CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 36. Disable Character Setting Examples
STEP ACTION
1 Desired character/value
Hex equivalent from ASCII
2
Chart
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT DISABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
292
the Disable Character is not used (not available).
ASCII Chart on the inside back cover of this manual to find the
hex equivalent for the desired character/value.
page 35 and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
Appendix D, Keypad, that represent the desired character/value in step
1 above. The second character will cause a two-beep indication.
ming Mode.
EXAMPLES
'd'
0x64
'6' and '4'
Table 36 for some examples of how to
'}' 'D'
0x7D 0x44
'7' and 'D' '4' and '4'
PowerScan™ PD9130/PBT9100/PM9100
Disable Command
Not Used
0xFF
'F' AND 'F'