Datalogic PowerScan 9100 Series Product Reference Manual page 301

NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK
character. ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
1. Determine the desired character or value.
2. Use the
3. Go to
4. Scan the bar code: SELECT NAK CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 33. NAK Character Setting Examples
STEP ACTION
1 Desired Character/Value
Hex equivalent from ASCII
2
Chart
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT NAK CHARACTER SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
ASCII Chart on the inside back cover of this manual to find the
hex equivalent for the desired character/value.
page 32 and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
Appendix D, Keypad, that represent the desired character/value in step
1 above. The second character will cause a two-beep indication.
ming Mode.
EXAMPLES
NAK
0x15
'1' and '5'
Table 33 for some examples of how to
$ @
0x24 0x40
'2' and '4' '4' and '0'
RS-232 Parameters
>
0x3E
'3' AND 'E'
289