3D Systems CubePro Setting Up page 7

Hide thumbs Also See for CubePro:

14.

Mount the jet wiper mounting posts to the back panel of the printer through the

keyhole slots.

NOTE: Slide the mounting pins downward.

15.

Align the jet wiper assembly bottom tab (A) with the slot in the ﬂoor (B) and slide the

jet wiper assembly downward.

NOTE: If the jet wiper assembly is fully seated into the keyhole slots but the

bottom does not rest on the thumbscrew head, remove the jet wiper and

turn the thumbscrew counter-clockwise until the jet wiper bottom rests on

the thumbscrew head and the keyhole slots are fully seated. This may

require repeated removals and re-installations of the jet wiper. If the keyhole

slots will not seat, the thumbscrew may need to be adjusted downward by

turning clockwise.

NOTE: Refer to the section titled

about adjusting the jet wiper scraper height.

16.

Remove the print pad from the box and place it onto the print platform with the round

magnet on the bottom of the pad inserted into the triangular opening on the platform.

Ensure the print pad is securely seated on the print plate.

Adjusting the Jet Wiper

for information

Table of Contents