3D Systems CubePro Setting Up page 14
Hide thumbs
Also See for CubePro:
- User manual (89 pages) ,
- Replacement manual (52 pages) ,
- Repair manual (40 pages)
Advertisement
14.
Cut off 2"/5 cm of print material from the end. Select the
NOTE: Ensure the material is not bent or creased. If the material is not
straight, pull out the damaged material from the cartridge. Cut off and
dispose the portion that is not straight.
15.
Insert the print material under the cartridge clamp roller of cartridge bay 1 and into
the material tube. Select the
16.
Continue to manually feed the print material through the material tube until it begins
to extrude from print jet 1 into the jet wiper assembly. Select the
continue.
NOTE: When the material reaches far enough into the extruder, the extruder
motor will assist with feeding the material further into the print jet.
checkmark
to continue.
checkmark
to continue.
checkmark
to
Advertisement
