3D Systems CubePro Setting Up page 6
Hide thumbs
Also See for CubePro:
- User manual (89 pages) ,
- Replacement manual (52 pages) ,
- Repair manual (40 pages)
Advertisement
12.
Using a 4mm hex head driver, attach the mounting posts to the jet wiper assembly
with the supplied screws and washers.
NOTE: Tighten the screws until the posts are secure.
CAUTION: Do not over-tighten the screws. The jet wiper assembly can break
if the screws are over-tightened.
13.
Move the jet wiper assembly to the back of the printer and locate the keyhole slots
(A).
Advertisement
