3D Systems CubePro Setting Up page 13
Hide thumbs
Also See for CubePro:
- User manual (89 pages) ,
- Replacement manual (52 pages) ,
- Repair manual (40 pages)
Advertisement
11.
To install cartridges and perform a test print, select START.
NOTE: Install the cartridge in cartridge bay 1 on the left side of the printer.
12.
Open the packaging and remove the thumbscrew from the new cartridge. Select the
checkmark
to continue.
13.
Pull out 12"/30 cm of material from the material cartridge. Select the
continue.
checkmark
to
Advertisement
Need help?
Do you have a question about the CubePro and is the answer not in the manual?