3D Systems CubePro Setting Up page 20

CAUTION: When using the touchscreen, use only light finger pressure to make
selections. Using anything sharp will damage the touchscreen display and will
void the manufacturer's warranty.
Print / Setup
PRINT allows the user to print a creation stored either on a USB mass storage device or
from the CubePro software.
SETUP allows the user to configure the printer, connect to a wireless or ad hoc network,
install cartridges, or view the printer status.
Navigation
Navigation between screens is performed by pressing the right or left arrows.
Materials
CARTRIDGE STATUS
installed. It also displays the estimated amount of material left in the cartridge.
Selecting CHANGE CARTRIDGE
allows the user to view the type and color of the material that is
allows the user to install cartridges in empty bays or replace