EMC VNX Series Parts Location Manual page 41

Data Mover DIMMs
Table 27 lists the part number location, description, and whether it is a FRU or CRU.
Table 27 VNX7500 platform SP CPU DIMM part numbers
Part number label
location
(Figure 33 on
page 40) Part number
100-562-866
100-562-479
Data Mover DIMMs are 4-GB SDRAM type memory for a total of 24 GB per Data Mover or
48 GB per DME. Figure 34 on page 42
part number label. Figure 35 on page 43
IMPORTANT
The DIMM part numbers are visible only when you remove the DIMM from the DIMM slot.
You must first take the Data Mover out of service, disconnect any Data Mover cables,
remove the Data Mover from the DME, then remove the Data Mover power supply/cooling
module from the Data Mover (see
the Data Mover CPU laying on an antistatic mat, lift the DIMM cover up in the Data Mover
CPU, and then remove the DIMM from the DIMM slot. Ensure that you remove only those
DIMMs that you intend to replace. For more information about removing and installing the
DIMM or memory module, refer to the
from the VNX Procedure Generator program.
not
The DIMM memory is
must follow the removing and installing the DIMM or memory module procedure
described in the Replacing a memory module
Procedure Generator program.
Note the orientation of the VNX7500 Block and File platform Data Mover DIMMs (see
locations DIMM 0, DIMM 1, DIMM 2, DIMM 3, DIMM 4, and DIMM 5 in
page 42). A label on the DIMM cover also identifies the DIMM slots as DIMM 0, DIMM 1,
DIMM 2, DIMM 3, DIMM 4, and DIMM 5. In the VNX7500 Block and File platform, the Data
Mover DIMMs are placed in slots 0, 1, 2, 3, 4, and 5.
Description
4-GB DDR3 DIMMs for base SP
8-GB DDR3 DIMMs for optional AP
shows an example of the Data Mover DIMM with a
shows the part number label location.
Figure 16 on page 20
Replacing a memory module
hot-swappable. Before removing or replacing any DIMMs, you
procedure available from the VNX
FRU


and Figure 17 on page
procedure available
Figure 34 on
EMC VNX7500 Parts Location Guide
DIMMs
CRU
20). With
41