Toro Multi Pro 5800 Operator's Manual page 51

Figure 60
1. Hydraulic tank
•
Rear filter, located on the machine frame.
Figure 61
1. Hydraulic filter
3. Clean the area around the filter mounting area.
4. Place a drain pan under the filter.
5. Remove the filter.
6. Lubricate the new filter gasket.
7. Ensure that the filter mounting area is clean.
8. Screw the filter on until the gasket contacts the
mounting plate, then tighten the filter one-half
turn.
9. Start the engine and let it run for about two
minutes to purge air from the system. Stop the
engine and check the hydraulic oil level and for
leaks.
10. Dispose of the used filter at a certified recycling
center.
g013791
2. Forward filter
g013790
2. Rear wheels
Changing the Hydraulic Oil
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Use 15 U.S. gallons (56 l) of the specified hydraulic
fluid or equivalent, see
(page 49).
Important:
Using any other oil may void the
warranty on some components.
WARNING
Hot hydraulic fluid can cause severe burns.
Allow the hydraulic oil to cool before
performing any maintenance to the hydraulic
system.
1. Replace the hydraulic oil filter; refer to Replacing
the Hydraulic Oil Filter.
2. Clean the area around one hydraulic hose fitting
on the bottom of the hydraulic oil tank
62).
1. Hydraulic tank
3. Place a large pan under the fitting.
4. Remove the hose fitting from the tank, allowing
the oil to drain into the pan
5. Install the hose and fitting to the tank and tighten
it securely.
6. Fill the hydraulic reservoir with approximately
14 US gallons (53 l) of specified hydraulic fluid
or equivalent, see
(page 49).
7. Start the machine and run it at idle for 3 to 5
minutes to circulate the fluid and remove any air
trapped in the system.
51
Hydraulic Fluid Specification
(Figure
Figure 62
2. Hydraulic hose and fitting
(Figure 62).
Hydraulic Fluid Specification
g014219