Filling The Fresh Water Tank; Filling The Spray Tank; Operating The Booms - Toro Multi Pro 5800 Operator's Manual

Filling the Fresh Water Tank

Always fill the fresh water tank with clean water before
handling or mixing any chemicals.
The fresh water tank is located on the ROPS, behind
the passenger seat (Figure
of fresh water for you to wash chemicals off of your
skin, eyes, or other surfaces in the case of accidental
exposure.
To fill the tank, unscrew the cap on the top of the tank
and fill the tank with fresh water. Replace the cap.
To open the fresh water tank spigot, turn the lever on
the spigot.
Figure 21
1. Fresh water tank
2. Filler cap

Filling the Spray Tank

Important:
Ensure that the chemicals you will
be using are compatible for use with Viton (see
the manufacturer's label; it should indicate if it
is not compatible). Using a chemical that is not
compatible with Viton will degrade the O-rings in
the sprayer, causing leaks.
Important:
The tank markings are for reference
only and cannot be considered accurate for
calibration.
Important:
After filling the tank for the first time,
check the tank straps for any play. Tighten as
necessary.
1. Stop the sprayer on a level surface, stop the
engine, and set the parking brake.
2. Determine the amount of water needed to mix
the amount of chemical you need as prescribed
by the chemical manufacturer.
3. Open the tank cover on the spray tank.
21). It supplies a source
g013788
3. Spigot
The tank cover is located in the center of the
top of the tank. To open it, turn the front half of
the cover counterclockwise and swing it open.
You can remove the strainer inside for cleaning.
To seal the tank, close the cover and rotate the
front half clockwise.
4. Add 3/4 of the required water to the spray tank
using the anti-siphon fill receptacle.
Important:
Always use fresh clean water in
the spray tank. Do not pour concentrate into
an empty tank.
5. Start the engine, set the pump switch to the On
position, and move the throttle lever to a higher
idle.
6. Set the agitation switch to the On position.
Important:
Prior to introducing wettable
powders into any Toro Spray System mix
the powders in a suitable container with
sufficient fresh water to create a free flowing
slurry. Failure to do so may result in
chemical deposits on the bottom of the tank,
degraded agitation, clogging of filters and
improper agitation rates.
Toro recommends using the approved
Eductor Kit for this machine. Contact your
Authorized Toro Dealer for more information.
7. Add the proper amount of chemical concentrate
to the tank, as directed by the chemical
manufacturer.
8. Add the remaining water to the tank.

Operating the Booms

The boom lift switches on the sprayer control panel
allows you to move the booms between transport
position and spray position without leaving the
Operator's seat. It is recommended to change boom
positions while the machine is stationary.
To change the boom position:
1. Stop the sprayer on level ground.
2. Use the boom lift switches to lower booms. Wait
until the booms reach the full, extended spray
position.
3. When the booms need to be retracted, stop the
sprayer on level ground.
4. Use the boom lift switches to raise the booms.
Raise the booms until they have moved
completely into boom transport cradle forming
the "X" transport position and the boom cylinders
are fully retracted.
Important:
To prevent damage to the boom
actuator cylinder, make sure the actuators are
fully retracted before transport.
24