Toro Multi Pro 5800 Operator's Manual page 19

1. Agitation control valve, open
Boom Valves
These valves turn the three booms on or off
14). If you ever need to manually turn off a boom,
rotate the knob on the valve clockwise to turn the
valve off or counterclockwise to turn it on.
Note:
Turning the boom valve manually can interfere
with the function of the fuses. The fuses should be
checked after manually rotating the valve.
Pro Foam Marker Switch Locations (Optional)
If you install the Pro Foam Marker kit, you will add
switches to the control panel for controlling their
operation. The sprayer comes with plastic plugs in
these locations.
Ultra Sonic Boom (Optional)
If you install the Ultra Sonic Boom, you will add a
switch to the dash for controlling its operation. The
sprayer comes with a plastic plug in this location.
Anti-siphon Fill Receptacle
To the front of the tank cover is a hose receptacle
with a threaded fitting, a 90 degree barbed fitting,
and a short hose which you can direct toward the
tank opening. This receptacle allows you to connect
a water hose to it and fill the tank with water without
contaminating the hose with the chemicals in the tank.
Important:
Do not lengthen the hose to allow
contact with the tank fluids. The distance from
the end of the hose to the uppermost water level
should be within local regulatory limits.
Figure 16
1. Anti-siphon fill receptacle
Tank Cover
g014359
The tank cover is located in the center of the top of
the tank. To open it, turn off the engine, then turn the
front half of the cover to the left and swing it open.
You can remove the strainer inside for cleaning. To
seal the tank, close the cover and rotate the front half
toward the right.
(Figure
19
Figure 17
2. Tank cover
g013787