Adjusting The Front Wheel Toe-In - Toro Multi Pro 5800 Operator's Manual

Adjusting the Front Wheel
Toe-In
Service Interval: Every 200 hours/Yearly (whichever
comes first)
The toe-in should be 0 to 1/8 inch (0 to 3 mm).
1. Check and fill all tires; refer to Checking Tire
Pressure.
2. Measure the distance between both of the front
tires at the axle height at both the front and rear
of the front tires (Figure
The distance between the front of the tires
should be 0 to 1/8 inch (0 to 3 mm) less than the
distance between the back side of the front tires.
Figure 51
1. Tire center line-back
2. Tire center line-front
3. If the measurement does not fall within the
specified range, loosen the jam nuts at both
ends of the tie rod
Figure 52
1. Jam nut
4. Rotate the tie rod to move the front of the tire
inward or outward.
5. Tighten the tie rod jam nuts when the adjustment
is correct.
51).
3. Axle center line
(Figure 52).
2. Tie rod
6. Ensure that there is full travel of the steering
wheel in both directions.
g002247
g002248
45