Unclogging A Nozzle; Selecting A Nozzle; Cleaning The Sprayer - Toro Multi Pro 5800 Operator's Manual

the neutral engine speed control to hold the engine
speed up to keep the agitation running.
•
You will obtain better results if the sprayer is
moving when you turn the booms on.

Unclogging a Nozzle

If a nozzle becomes clogged while you are spraying,
you can clean it using a hand spray bottle of water
or a toothbrush.
1. Stop the sprayer on a level surface, stop the
engine, and set the parking brake.
2. Set the master boom switch to the Off position
and then set the pump switch to the Off position.
3. Remove the clogged nozzle and clean it using a
spray bottle of water or a toothbrush.

Selecting a Nozzle

The turret bodies can accept up to 3 different nozzles.
To select the desired nozzle:
1. Stop the sprayer on a level surface, stop the
engine, and set the parking brake.
2. Set the master boom switch to the Off position
and set the pump switch to the Off position.
3. Rotate the turret of the nozzles in either direction
to the correct nozzle.

Cleaning the Sprayer

Important:
You must always empty and clean
the sprayer immediately after each use. Failure
to do so may cause the chemicals to dry or
thicken in the lines, clogging the pump and other
components.
Toro recommends using the approved Rinse Kit for
this machine. Contact your Authorized Toro Dealer
for more information.
Clean the spray system after each spraying session.
To properly clean the spray system:
•
Use three separate rinses.
•
Use the cleaners and neutralizers as
recommended by the chemical manufacturers.
•
Use pure clean water (no cleaners or neutralizers)
for the last rinse.
1. Stop the sprayer, set the parking brake, and turn
off the engine.
2. Locate the tank drain valve on the rear of the
machine (Figure
pump, attached to the support bracket.
22). The valve is to the rear of
1. Tank drain handle
Open the valve to drain any unused material
from the tank and dispose of it according to
local codes and the material manufacturer's
instructions (Figure
the lynch pin on the bracket securing the drain
valve to the machine and let the valve rest on
the ground . This allows any residual material
in the line to drain.
1. Valve open
2. Lynch pin
3. When the tank has drained completely, install
the valve to frame with the lynch pin removed
previously and close the drain valve
4. Fill the tank with at least 50 US gallons (190 L)
of clean fresh water and close the cover.
26
Figure 22
23). After draining, remove
Figure 23
3. Valve closed
(Figure
g014158
g014159
23).