Toro Multi Pro 5800 Operator's Manual page 17

Hour Meter
The hour meter (Figure
of hours the engine has run. The hour meter starts
to function whenever the key is turned to the Run
position.
1. Hour Meter location
Sprayer Controls
1. Oil pressure and battery
light
2. Water temperature and
glow plug light
3. Pressure gauge
Application Rate Switch
The application rate switch is located on the dash to
the right of the steering wheel
hold the switch forward to increase the spray system
10) indicates the total number
Figure 10
Figure 11
4. Application rate switch
5. Dash controls for optional
kits
6. Ignition switch and key
(Figure 13). Press and
pressure, or press and hold it rearward to decrease
pressure.
Pressure Gauge
The pressure gauge
dash. This gauge shows the pressure of the fluid in
the system in psi and kPa.
Master Boom Switch
The master boom switch is located on the floor board
of the machine cab and to the left of the operator. It
allows you to start or stop the spray operation. Press
the switch with your foot to enable or disable the spray
system (Figure
g013747
1. Master boom switch
Boom Switches
The boom switches are located on the control panel
to the right of the seat
forward to turn the corresponding boom section on
and rearward to turn them off. When the switch is
turned on, a light on the switch illuminates. These
switches will only affect the spray system when the
master boom switch is on.
g013751
17
(Figure 11). is located on the
12).
Figure 12
(Figure 13). Toggle each switch
g002200